Transform the rear bumper of your Ford Focus MK2.5 ST225 with this sleek and stylish finned diffuser panel.

Enhance the overall appearance of your car and stand out from the crowd. This replacement panel is a must-have for any car enthusiast looking to upgrade their vehicle.

Manufactured from fibreglass and supplied as pictured in a gloss black gel coat.

This part requires the removal of the OEM diffuser then fits into place with the use of the two original fixings to hold it.

Please Note:

This product may require some trimming / sanding to ensure the perfect fit and we advise for the perfect finish to have the product sprayed gloss black.

Fitting guidance
1 - Make sure the clips are sanded down to a thickness of around 4mm max

2 - Using a lubricant like WD40, spray the clip areas on the cars bumper.

3 - Using a blunt screw driver or such, prise open the bumper clips holes. Doing this will help the new diffuser clips slot in.

4-Around the bumper where the diffuser return will sit, there are some raised plastic sections, with a sharp implement remove these .

5- Then starting from one side of the diffuser, clip it in position, you will notice once a few clips are in it will become a bit tougher to clip in place.

In these tight/tougher areas of the diffuser you’ll need to push from behind the bumper with one hand and push the diffuser in with the other, forcing the diffuser into the bumper.

6- If the clips look like they are not lining up, lift the diffuser up whilst still pushing against the bumper. You may need to repeat step 5 for all the clips across the top section of the diffuser. 

The more clips you get in, the easier it becomes and will end up in place towards the last few clips.

We understand these diffusers can be harder to fit than most of our products so please get in touch if any help fitting is required.