CHOATE 5.9L Short Block Daily Driver Engine 1998.5-2000- Cummins Dodge Diesel

Engine Manufacturer: CHOATE Engineering Performance CHOATE Part Number: CEP59CSD98500 Fitment : Fits 1998.5-2000, Dodge 5.9L Cummins Equipped Vehicles

This 5.9L Short Block Dodge Cummins Diesel Engine Includes:

• Full CNC blueprint machining, (bore, deck, hone, and line honed).
• We blue print bore the Cylinder bores to a true 90 degrees from the crankshaft center line, prior to diamond honing to within .0002 inch for precise piston to cylinder bore clearances.
• We will main bore and line hone the crankshaft to precisely align the crankshaft in the engine block.
• We bore the block back to the crankshaft center line and hone the block to Ra 13 finish. The piston diameter measured to the nearest .0001 inch matched to cylinder bores.
• We will surface the Cylinder block on this 5.9L Cummins Short Block to a finish of RA30 or lower, to meet factory specification in both flatness and smoothness for the block to head sealing surface. This is mandatory for proper sealing of a MLS Gasket.
• Connecting Rods, New Damper - Check both wrist pin and crank pin to rod clearances.
• New upgraded Pistons .10 - .30 inch over - New Pistons, Rings, Pin retainers weight matched prior to crank balancing
• Crankshaft - Balanced with the Rotational assembly checked for run-out inspected for fatigue. Crankshaft is Polished and ground to .0005 concentricity or less
• New Rod, Main and Cam Bearings
• Camshaft - Polished and Inspected
• Install Rear Main Seal
• Install New Bed Seals
• Install New Rear Cover Gasket
• Install Upper and Lower Oil Pan gaskets
• Install Pickup Tube O-ring
• Rear Cover Installed

CHOATE Engineering Performance Crate Engine Features:

The CHOATE 5.9L Cummins Short Block is rated for 500 HP and fully balanced. It is the perfect engine for spirited daily driving, consumer level towing and everyday life.

Common Issues With The Dodge Cummins 5.9L Engine (and how we fix them):

Cylinder Heads- While there aren't as many issues with the bottom end of the Cummins, there are really BIG problems in the head department. Valve seats fallout contacting the piston and cause catastrophic failure. We machine oversize valve seats within creased press fit area to remedy this issue. Stamped gallery plugs in the heads blow out causing a mixture of oil and coolant, destroying the bearings. We thread the head and insert threaded plugs to make sure this issue never rears its ugly head. Plus: Freeze plugs in the block blow out leaving you at best stranded on the side of the road, at worst, with a severely overheated engine in need of Remanufacturing. Every new Choate Cummins engine comes standard with billet freeze plugs that are inch blow out proof inch using a tie bar bolting them into the side of the block.