EJ5A-12A650-NE - You must match this!

This ecu will interchange or replace the following ecu part numbers on 2015 Ford Escape models:

EJ5A-12A650-NE

ECU has been tested with our state of the art vehicle simulator which tests over 25 circuits of the ECU! Some of those are listed below:
• ECU Starter relay circuit tested good!
• ECU Starter A/C relay circuit tested good!
• ECU powered up and has communication!
• ECU injector and coil circuits tested good!
• ECU Purge circuit tested good!
ECU EGR control, VVT and O2 heater circuits tested good and much more!

• Disconnect the negative terminal of the battery. Make sure the battery connector is not touching the battery post.
• Disconnect and remove the module to be replaced.
• Install and connect the replacement module.
• Connect the negative terminal of the battery.
• See "Programming / PATS Security" below for additional install instructions. 

For Plug and Play you must do the following three steps:

Step 1: Match your part number per above fitment guide

Step 2: Program ecu to your VIN. We offer free VIN programming with your purchase. Just message us with your VIN after purchase and our programmers will take it from there! 

Step 3: If your vehicle has PATS security (Most Ford/Lincoln/Mercury's do) you must have your keys programmed. We recommend you have this done by your local locksmith. In most cases they will travel to your location and the process takes less than 30 minutes. No towing necessary and your local locksmith will be cheaper than a dealer.

• Mounting points are all open and intact
• Pins perfect, none are broken or bent
• Lock tabs in place
• Connector plastic may have minor chip but pins, guides and lock tabs are in place.

This ECM comes with a 90 day warranty from the date of purchase. Please keep a copy of your purchase record which we will send with your item.