General purpose φ35 straight Increases intake air volume and contributes to power up.

Product introduction: This type is not easily affected by conditions. It has a hood and is highly effective against dirt, dust, and rain. Improves intake efficiency and increases power. Please pay attention to the installation angle. If the cover is installed upside down, water may collect inside the cover during rain and may block air intake. The dimensions are the length from the top of the filter to the bottom of the rubber pipe when the filter is held vertically. Carburetor setting is required when installing. This is an air filter recommended for normal carburetors. The intake efficiency will change, so carburetor settings are required. When driving in the rain, moisture may enter the filter and change the carburetor settings. Regarding exhaust gas regulated models starting from the 2000 model: Due to lean combustion, the exhaust gas regulated models may not be able to be set properly, so it is not recommended to install power filters, etc. Regarding F1 cars: Do not install power filters, air funnels, etc. on F1 cars as it will disrupt fuel regulation. However, this does not apply if a device that can adjust the fuel (injection controller Kitaco I-MAP) is installed and settings can be made. If the filter diameter is a few millimeters smaller than the vehicle's carburetor diameter, it will be a little tight to fit, but you can install it by pushing it in. If a long rear shock is installed, the filter may interfere with the body. Caution (Disclaimer) > Please read 4990852510948


Manufacturer: KITACO
Brand: KITACO
Model name: Super Power Filter
Packing size: ‎20.1 x 13.6 x 7.4 cm; 172.37 g
Product model number: ‎515-0500351
Color: ‎Red anodized
Product weight: ‎172 g