A-100 Exterior Latex is a 100% acrylic, flat-finish exterior paint designed for quality performance on residential and commercial buildings. It is suitable for use on a variety of substrates including aluminum, vinyl, wood siding, shakes, shingles, plywood, masonry, and metal.

This paint is used as a topcoat and may be paired with various primers depending on the substrate:

• Aluminum/Galvanized Steel: 2 coats A-100 (air and surface temp must be ≥50°F)
• Concrete Block/CMU: 1 coat Loxon Acrylic Block Surfacer + 2 coats A-100
• Brick, Stucco, Cement, Concrete: 1 coat Loxon Concrete & Masonry Primer or Loxon Conditioner + 2 coats A-100
• Cement Composition Siding/Panels: 1 coat Loxon Concrete & Masonry Primer or Loxon Conditioner + 2 coats A-100
• Plywood: 1 coat Exterior Latex Primer + 2 coats A-100
• Vinyl Siding: 2 coats A-100 (VinylSafe® colors recommended for dark shades)
• Wood (Cedar, Redwood): 1 coat Exterior Oil-Based Wood Primer + 2 coats A-100
• Wood Composition Board (Hardboard): 1 coat Exterior Oil-Based Wood Primer + 2 coats A-100

Ideal for exterior surfaces where a flat, mildew-resistant finish is needed. Compatible with aluminum, vinyl, wood, masonry, and metal substrates.

• Coverage: 350–400 sq. ft. per gallon at 4 mils wet (1.3 mils dry)
• Application Methods: Brush (nylon-polyester), Roller (3/8–3/4 inch nap), Airless Spray (2000 psi, 0.015–0.019” tip)
• Temperature Range: Minimum application temp is 35°F; do not apply if air/surface/material temps may fall below 35°F within 48 hours
• Dry Time at 50% RH:
• Touch: 2 hours (at ≥35°F)
• Recoat: 24–48 hours (at 35–45°F), 4 hours (at >45°F)
• VOC: <50 g/L (0.42 lbs/gal)
• Solids by Volume: 34% ±2%
• Weight per Gallon: 10.99 lbs
• Shelf Life: 36 months (unopened)
• Film Thickness: 4 mils wet recommended
• Mildew Resistance: Contains mildew-inhibiting agents

• Not UV-stable after cure unless otherwise topcoated
• Do not use standard latex primers below 50°F
• Not for use on floors
• Clean tools with soap and water; rinse spray equipment with solvent
• Use appropriate caulks after priming where needed
• Observe all surface-specific preparation guidelines, especially for masonry, wood, and metal
• Do not use dark colors on vinyl unless VinylSafe® colors are chosen to avoid warping